Datasat RS20i Specifications Page 120
- Page / 140
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
RS20i Installation and Operating Guide Page 120
RS20i Installation & Operating Guide Document # 9301H52900 Ver. 1.01
The screen displays a series of automation buttons, one for each automation output signal (GPO), and a
circle above it that represents the signal input (GPI) state (GPO19 and 20 are outputs only and do not
have an input indicator circle). The input indicator is white when the signal is high or just unconnected.
The input indicator turns green when there is a low signal applied to the pin.
To verify that the RS20i is properly receiving an input from an external source you would
need to make the external device send a low signal on that pin. Then confirm that the signal
is received by the RS20i by checking if the corresponding circle turns
green.
Example: The button at right illustrates when receiving an input signal on
GPIO1.
To test an output signal, press the automation button. It creates a low pulse on the
corresponding output pin. The button turns green in conjunction with the output signal being
low.
Example: The button at right when GPIO1 has been selected. Note that the
circle will also turn green after pressing the button, indicating that it is reading
the low signal on the same pin.
5.0 Maintenance and Troubleshooting
Check the Datasat Digital Entertainment Online Support site, at www.datasatdigital.com, for
the latest information on maintenance, troubleshooting, and RS20i software versions.
5.1 Routine Maintenance
We recommend that every six months you vacuum the outside of the unit to remove dust, especially
around ventilation holes.
Clean the touch screen as needed with a soft cloth and non-abrasive cleaning solution suitable for
cleaning LCD screens.
5.2 Troubleshooting
The following table provides troubleshooting data for the RS20i.
PROBLEM SOLUTION
The touch screen display is off-
centered
See Touch Screen Calibration, below
The Home screen displays NoLock See NoLock below
Volume control not functioning See Volume control Not Functioning below
- RS20i Audio Processor 1
- Installation and 1
- Operating Guide 1
- Notices 2
- Copyright 2
- Record of Changes 3
- Regulatory Notices 3
- TABLEOFCONTENTS 4
- 3. APPENDICES 6
- Introduction 7
- About RS20i Audio Processor 8
- Limited Warranty 8
- FACTORY WARRANTY INFORMATION 9
- Software License Agreement 9
- Unpacking 11
- Caution Notices 12
- Part 1: Operation 13
- 1.0 Operating RS20i 14
- 2Update 15
- 258 for more details 15
- Navigating through the Menus 17
- 1.4 The Home Screen 18
- 1.4.3 Manual Automation 21
- PROBLEM SOLUTION 22
- 1.5.1 Over Temperature Alert 23
- 2.0 Installation and Set Up 26
- 2.3 Installation Overview 28
- 2.5 Mounting and Connection 30
- 2.5.4 Power Supply 32
- 2.6 Navigating the Menus 33
- 2.7 About Inputs 34
- Output preset: 35
- 2.8 Factory Presets 36
- 2.8.2 Default EQ 37
- 2.8.3 Default Output Presets 37
- 2.9.1 Equipment Requirements 38
- 2.10.2 Set the EQ 44
- 2.13 Final Adjustments 48
- 2.14 Copy Input 48
- 4.0 Setup Menus 51
- 4.1 The Setup Button 56
- 4.2 System Setup Screen 56
- 4.2.3 Access Control 60
- Figure 36. “Expert” Nav Mode 62
- 4.2.4 View Log File 63
- 4.2.5 System Info 63
- 4.2.7 System Monitor 64
- 4.3 Inputs 65
- 4.3.2 Startup Input 66
- 4.3.3 Edit Inputs 66
- 4.3.4 Assign Input Buttons 67
- 4.3.5 Input Source 69
- 4.3.6 Input Options 71
- Operation 78
- Decoder Setup Options 78
- 4.3.7 EQ Setup 79
- Figure 62. Copy EQ Settings 84
- 4.3.8 Output Preset 86
- 4.3.9 Audio Levels 104
- 4.4 Network 106
- 4.5 Automation 111
- 4.5.1 Events 112
- 4.5.2 Macros 117
- 4.5.3 Automation Buttons 118
- 4.5.4 Automation Test Screen 119
- 5.1 Routine Maintenance 120
- 5.2 Troubleshooting 120
- Touch Screen Calibration 121
- 5.3 Error Messages 122
- Figure 98. Downloading Error 123
- HDMI 1.4a Dolby/DTS Decoder 136
- Digital Audio Decoders 137
- Signal Inputs 137
- Signal Outputs 137
- Audio EQ 138
- Audio Delays 139
- Automation Inputs/Outputs 139
- Management 139
- Power Requirements 139
- Hardware Dimensions 139
- Regulatory Compliance 140
- E&OE 140
© 2020, manymanuals.com. All rights reserved. | 1.242 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals