Datasat RS20i Specifications download pdf (Page 23)

RS20i Installation and Operating Guide Page 23

RS20i Installation & Operating Guide Document # 9301H52900 Ver. 1.01

1.5.1 Over Temperature Alert

If the internal temperature of the RS20i reaches a critical level of 50°C or greater, a red flashing

alert indicator will appear.



Figure 10. Over Temperature Alert message

The flashing alert message appears only on the Home screen. The RS20i will remain operational

and the menus can be accessed as usual. The actual circuit board temperatures appear on the

System Info page (Setup > System Info). The alert condition overrides, or temporarily disables

the screensaver mode if it is set. The alert will stop if the temperature cools below 50°C.

Note: This alert message often indicates that there is a problem with proper air flow through

the vent holes on both sides of the RS20i chassis. Check that there is nothing obstructing

these air vents. Be sure that the fan is spinning (you will feel air blowing out of the RS20i

from the fan). If the vents are clear and the fan is spinning, yet the temperature alert does not

stop, call your installer for service.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 139 140

No comments

Datasat RS20i Specifications Page 23